Instructions

Enabling MDC on a Haas Control

To enable MDC (Machine Data Collection) on a Haas machine, follow these steps:

Note: The IP of the machine needs to be setup already

1. Access the control panel of the Haas machine.
2. Navigate to the settings menu.
3. Locate the MDC settings section.
4. Set Setting "143 Machine Data Collect port" to 5051.

Enabling Focas on a Fanuc control

To enable Focas on a Fanuc CNC Machine, perform the following steps:

Note: The IP of the machine needs to be setup already

1. Access the CNC machine control panel or interface.
2. Navigate to the communication or network settings.
3. Enable Focas communication protocol.
4. Configure the IP address and port for Focas communication.
5. Save the settings and reboot the CNC machine.